Document Version: V1.3
146
Procedure:
Ensure that the NVR has connected to the internet successfully before configuring the
email alarm.
Step 1 Enable the SMTP service of the sender's email. Gmail is taken as an example here. (If it is
enabled, skip this step.)
1.
Open the browser, and log in to your Gmail. Click (Settings) in the upper-right
corner See all settings.
2. Click Forwarding and POP/IMAP on the settings page. Find IMAP access, tick Enable
IMAP, and click Save Changes at the bottom of the page.
To Next Page
Loading...
