Document Version: V1.3
151
Wait a moment, when the connection status is Connected, the DDNS is configured
successfully.
Step 3 To configure the UPnP, Refer to the Internet User Using the IP Address to Access the Web
UI of the NVR for detailed steps.
---End
After the setting completes, the user can use the domain name to successfully access the web UI
of the NVR. When configuring the UPnP, the external port of the HTTPS is not the default port
number, the access format is https://domain name: external port.
The access address is https://jointnet.dyndns.org in this example.
UPnP
Overview
Navigate to Configuration > Network > UPnP.
The internet user cannot access the NVR by default. The UPnP function enables the internet user
to access the NVR through an external IP address.
After the UPnP function is enabled, the NVR will open the internal network port and external
network port of the designated service, and identify the corresponding service with the LAN IP
address and the internal network port. If the NVR receives a request from the external network
To Next Page
Loading...
