Step 7
Log in to the web UI of the Mesh device again, and navigate to Network Status to check
whether the AP mode is configured successfully as shown below.
---End
If there is another network device with the same login domain name (tendawifi.com) as the Mesh
device, log in to the upstream router and find the IP address obtained by the Mesh device in the client
list. Then you can log in to the web UI of the Mesh device by visiting the IP address.
To access the internet, connect your computer to a physical port, or connect your smartphone to
the Wi-Fi network.
You can find the Wi-Fi name and password on the WiFi Settings page. If the network is not
encrypted, you can also set a Wi-Fi password on this page for security.
To Next Page
Loading...