Power jack.
You can use the included power adapter to power on the device.
10/100 Mbps PoE multiplex network port for power input and data
transmission.
- When the power socket is not available near the CPE, the CPE can be
powered on by connecting this port to the PoE injector using an
Ethernet cable.
- When the CPE is powered on with the power adapter, this port can be
used to connect computers, switches and IP cameras.
10/100 Mbps auto-negotiation Ethernet port.
Used for connecting computers, switches and IP cameras.
Reset button.
When the Power indicator lights solid on, hold the button down for about 8
seconds and release it until all indicators light up and then turn off. The CPE
is restored to factory settings.
Power cord/Ethernet cable inlet.
II Set up the CPE
At least two CPEs are required for bridging.
To Next Page
Loading...