Option 1: Automatic bridging (recommended)
Peer-to-peer bridging
- Automatic bridging only works for CPEs in factory settings.
- Peer-to-peer bridging takes effect within one minute after the CPEs start. Automatic bridging could fail if three or
more powered CPEs in factory settings are placed nearby.
- When the CPEs are powered on using Ethernet cables, CAT5e or better Ethernet cable is recommended, and the
length should not exceed 50 meters.
- This CPE supports 9 - 13V DC power supply. You can use the included power adapter, centralized power supply for
camera monitoring, or outdoor solar cells to power on the CPE as required.
1. Place two CPEs in factory settings next to each other, and remove the cover of the CPEs as shown in Ports/buttons.
2. Use an Ethernet cable (CAT5e or better Ethernet cable is recommended) to connect the PoE/LAN port of the CPE to the
PoE port of the PoE injector.
3. Use the included power adapter to connect the PoE injector to a power source. The Power indicators of the two CPEs light
up.
4. The two CPEs bridge to each other automatically within 1 minute. Please wait.
After the bridging succeeds, the DHCP servers of the CPEs are disabled automatically. The IP address of the CPE in Client
mode will be changed into 192.168.2.2.
Successfully bridged CPEs are shown as below.
To Next Page
Loading...