Peer-to-multiple peers bridging
- The automatic peer-to-multiple peers bridging lasts for 30 minutes. During this period, the CPE working in AP mode
must be kept powered on. Otherwise other CPEs will fail to perform automatic bridging.
- One CPE can be bridged to 15 other CPEs at most.
1. Perform Peer-to-peer bridging to bridge any two CPEs.
2. Within 30 minutes after peer-to-peer bridging succeeds, place other CPEs in factory settings near the CPE working in AP
mode and power them on. When the LED1, LED2 and LED3 indicators of them are blinking, the bridging of all other CPEs
succeeds.
After successful peer-to-multiple peers bridging, the DHCP servers of the CPEs are disabled automatically, and the IP address
of CPEs in Client mode will be changed into 192.168.2.2. If required, please visit www.tendacn.com to download the CPE
management software and install it on your computer to change the IP addresses in batch.
To Next Page
Loading...