Tennant B2 - Operating the Hand Brake; Emptying the Bag(s)

OPERATION EN
7
B2 331081 (07--04)
OPERATING THE HAND BRAKE
1. Push the hand brake handle forward to lock the
machine wheels. Refer to Fig. 9.
FIG. 9
2. Pull the hand brake handle to the rear to unlock the
machine wheels.
EMPTYING THE BAG(S)
Empty and clean bag(s) after each use.
FOR SAFETY: Before leaving or servicing machine,
stop on level surface, turn off machine, set safety
brake, and remove key.
1. Place a refuse container beneath the zipped hole in
the back of the bag.
FOR SAFETY: When emptying bags, wear
protective gloves and eye protection. Avoid contact
with sharp objects.
2. Loosen neck of bag (and liner , if equipped) from
around the duct. Refer to Fig. 10.
FIG. 10
3. Open bag (and liner, if equipped) and dump contents
into a refuse container positioned underneath the
bag. Refer to Fig. 11.
FIG. 11
4. Ensure the bag is empty, free of dust, and not
damaged.
5. Close the bag (and liner, if equipped).
6. Slide duct hole in the bag (and liner, if equipped)
back onto the duct and over the bag retainer.