Before You
Check bolts and nuts
Check the front wheel
Please check and tighten these bolts again after riding 200km. Perform
the same checks every 1000km after this or every 600km in complex road
conditions.
Check and tighten these bolts and nuts properly before your first ride,
with provided tools.
The bolt at the top of the handlebar, with a 4mm hex key.
The 2 bolts on the stem, with a 4mm hex key.
The bolts on the brake levers, with a 4mm hex key.
The bolts on the brake caliper, with a 5mm hex key.
The ve bolts around the crankset, with a 5mm hex key.
Open and close the quick release lever, and see if it is securely locked. A
properly locked quick release requires considerable effort to open.
It is imperative to check the condition of the front wheel before every ride,
especially after you park the bike in public areas.
Check the brakes
Check the tire pressure
Before your first ride, ensure that the brake lever is securely attached to the
handlebar, and the brake caliper is securely attached to the front fork.
When braking with both brakes on a at road at a speed of 16km/h, the braking
distance should be ≤ 5m. When braking with the rear brake only, the braking
distance should be ≤ 10m. If you find the braking power insufficient, please
contact the TENWAYS customer support team as soon as possible.
Before your rst ride, pump up the tires to 50-75 psi.
26
To Next Page
Loading...
