20
Setup
Step 1
Connect two frame parts (1) using screw (10), washer (11) and cap nut (21). Use bottom
holes for this purpose.
Repeat this step until you have four frame part groups (1+1).
(Only tighten the screws completely when all the parts are assembled)
Step 2
Fasten the frame part groups (1+1) with screws (9) and washers (11) at the top of he
support legs (2).
Step 3
Insert the roof supports (3) into the roof support extensions (4) and the roof textile
tensioners (5). Connectors must engage audibly.
1+1
2
21
P160150_TEPRO_5524,5525,5526,5527,5528,5529_Waya_Pav_DE_GB_20161003.indd 20 18/11/16 11:46 AM
To Next Page
Loading...