TERA
TR-500
20
Channel Scan Function
NOTE: this function is disabled when radio is shipped from the factory. The channel
scan function may be turned ON with the optional programming software and cable. To
enable this function, go into the programming software and select which channels you
would like to scan by selection “Yes” in the Scan Add column. You can scan from 2-15
channels. To start the channel scan mode, rotate the top mounted channel selector
knob on the radio to channel “16” and the radio will begin to scan your pre-selected
memory channels. To answer a calling station when scanning, press the radio’s PTT
button and talk. The radio will transmit on the last received channel while in the scan
mode. The scan feature will then auto resume channel scanning after 5 seconds of your
last transmit or receive audio activity on that channel. Channel “16” is not available for
a memory channel if the scan function is enabled for use.
Side Key Operation
The radio’s small side keys are programmed from the factory to the following:
Top small key: Short Press: Battery Level, Long Press: Channel Lock.
Bottom small key: Short press: Select TX Power level, Long Press: Monitor function
on. The radio’s side keys may be re-programmed to perform other functions with the
optional programming software and cable.
To Next Page
Loading...