How to fix no vacuum on Teradyne Z1820 Test Equipment?
If your Teradyne Test Equipment has no vacuum, ensure the vacuum is plugged in and turned on. If you're using a local pump, press the Pump Start switch. Also, verify that the vacuum control switches are turned on.
How to troubleshoot no power on Teradyne Z1820?
If your Teradyne Test Equipment has no power, try turning the Power Control switch off and on. If the AC power cord isn't connected, turn off the main breaker on the rear panel before connecting the power cord. After connecting, ensure the main AC breaker is on.
What to do if Teradyne Test Equipment is hissing?
If you hear a hissing noise while running the Teradyne Test Equipment, it's likely that the fixture or the board-under-test is leaking. Remove the fixture or board and have a qualified technician repair the defect.
General| Category | Test Equipment |
|---|---|
| Model | Z1820 |
| Manufacturer | Teradyne |
| Maximum Pin Count | 1024 |
| Applications | Semiconductor testing |
| Power Requirements | 200-240V AC, 50/60Hz |
| Frequency Range | Up to 1 GHz |
| Measurement Parameters | Voltage, Current, Timing, Frequency |
To Next Page
