To Next Page
F
Faith WrightAug 21, 2025
What to do if the pressure switch alarm continues to sound at the down limit with a rated load in the platform on Terex Scissor Lifts?
- JJennifer Cantrell DVMAug 21, 2025
If the pressure switch alarm persists at the down limit with a rated load on your Terex Scissor Lifts, you can try the following: 1. Reset the system by turning off the red emergency stop button, waiting three seconds, and turning the machine back on. 2. Raise the down limit switch as it may be out of adjustment. 3. Ensure that the platform has the correct rated load. 4. Adjust the pressure switch by turning the nut 1/4 turn into the hydraulic line, or repeat the calibration procedure if the overload system is not properly adjusted.
General
