Terex Aerial Work Platforms, 6464 185th Ave NE Redmond WA 98073, Ph: 800-536-1800, 425-881-1800
1 of 2
First Notice
Product Notice
170016
Mandatory Action Required
North America
Asia-Pacific
Date:
August 21, 2017
Models Affected:
SX-135 XC
Serial Numbers Affected:
SX135H-101 to 159
SX135H-161 to 168
SX135H-170, SX135H-173 and SX135H-174
Subject:
Load Cell Replacement and Software Update
Allowable Hours:
6 hours
Issue:
Genie has become aware of the following issues on the machines referenced above.
The software installed on the machines referenced above does not fully comply with the prevailing
standards EN280 and AS1418. The control system software must be updated on the affected
machines.
In extreme temperature conditions, the load sensing system installed on the machines referenced above
may deviate from the load cell engineering specification. This can result in nuisance faults of the load
sensing system.
Action(s) Required:
1 Locate the affected machines referenced above within your fleet.
2 Order Load Cell Kit PN 1280949GT and install on your machine.
Note: Updating the control system is included in the instructions to replace the load cell.
Completion of this Product Notice must take place as soon as possible, but no later than 90 days from
receipt of the kit.
3 Fill out and sign the completion form attached to the installation instructions and fax or email to Terex AWP
Warranty Department. This will serve as verification that you have completed this Product Notice.
Continued Use Instructions:
The machine may remain in service.
To Next Page
Need help?
General
