Section 150-0020
SM 1971 4-00
5
Centre Axle - Differential Drive Head
SM - 1113
12. Press the thru-drive differential case assembly
(13 thru 20) out of intermediate flange (12), as shown
in Fig. 7.
13. With a bearing puller, pull ball bearing (10) off the
bearing journal of differential case half (14).
Fig. 7 - Pressing Differential Assembly
From Intermediate Flange
SM - 1114
Fig. 8 - Separating Differential
SM - 1115
Fig. 9 - Removing Shifter Fork Lock Pins
SM - 1116
Fig. 10 - Removing Shifter Fork And Piston
14. Index mark differential case halves (14 & 20).
Remove bolts (13) from differential case half (14) and
separate the differential case halves. Remove thrust
washer (15), side gear (16), thrust washers (17),
pinion gears (18) and spider (19). Refer to Fig. 8.
15. Remove bolts (45) from shifter fork lock pins (44).
Push down on piston (36) and remove shifter fork lock
pins (44) with seal rings (46) from differential housing
(4) as shown in Fig. 9. Remove and discard seal rings
(46).
16. Remove shifter fork (23) with thrust blocks (24),
piston (36) with centring ring (37) and spring (38) from
differential housing (4). Also remove shift collar (21).
Refer to Fig. 10.
Courtesy of Machine.Market
To Next Page
