8-88-8
MISCELLANEOUS SERVICINGMISCELLANEOUS SERVICING
WHEN REQUIREDWHEN REQUIRED
Seat Belts -Seat Belts -Inspect seat belts and replace if damaged.Inspect seat belts and replace if damaged.
Note:Note: Replace seat belts at least once every three years, regardless ofReplace seat belts at least once every three years, regardless of
appearance.appearance.
Windscreen Wipers and Washers -Windscreen Wipers and Washers -Inspect wiper blades and replace ifInspect wiper blades and replace if
damaged. Top up washer reservoir.damaged. Top up washer reservoir.
Wheel Rim Nuts -Wheel Rim Nuts -After first 10 hours of operation re-torque nuts to 690 NmAfter first 10 hours of operation re-torque nuts to 690 Nm
(510 lbf ft). Check torque every 50 hours (weekly) thereafter.(510 lbf ft). Check torque every 50 hours (weekly) thereafter.
EVERY 10 HOURS OF OPERATIONEVERY 10 HOURS OF OPERATION
Walk Around Inspection -Walk Around Inspection - Inspect the machine as described in Section 4.Inspect the machine as described in Section 4.
Engine -Engine -Visually check engine for damage, loose or frayed belts and listen forVisually check engine for damage, loose or frayed belts and listen for
any unusual noises.any unusual noises.
Engine Air Cleaner(s) -Engine Air Cleaner(s) -Check air cleaner piping, hoses and clamps. Change airCheck air cleaner piping, hoses and clamps. Change air
cleaner element only when air cleaner flow restriction warning light illuminates.cleaner element only when air cleaner flow restriction warning light illuminates.
Service vacuator valves daily. Inspect and remove any obstructions from theService vacuator valves daily. Inspect and remove any obstructions from the
vacuator valve lips. Valve lips should be open and pliable with engine stopped.vacuator valve lips. Valve lips should be open and pliable with engine stopped.
Note:Note:Service air cleaner(s) more often under extremely dusty operatingService air cleaner(s) more often under extremely dusty operating
conditions.conditions.
Radiator Header Tank -Radiator Header Tank -
Check coolant level and add if lCheck coolant level and add if low. Fill radiator headerow. Fill radiator header
tank with coolant until coolant reaches the bottom tank with coolant until coolant reaches the bottom of the filler neck and holds atof the filler neck and holds at
that level.that level.
Note:Note:Any time a significant amount of coolant is added, the DCA4 concentrationAny time a significant amount of coolant is added, the DCA4 concentration
MUST be checked. If the concentration is low, engine damage will result.MUST be checked. If the concentration is low, engine damage will result.
Conversely, over-inhibiting antifreeze solutions can cause silicate dropout. ReferConversely, over-inhibiting antifreeze solutions can cause silicate dropout. Refer
to Section 210-0010, COOLING SYSTEM, in the to Section 210-0010, COOLING SYSTEM, in the Maintenance Manual.Maintenance Manual.
To Next Page
Loading...
