8-108-10
Note:Note:
The fan belt is maintained to the correct belt tension by a spring loadedThe fan belt is maintained to the correct belt tension by a spring loaded
idler arm, therefore, there is no need to check or adjust belt tension.idler arm, therefore, there is no need to check or adjust belt tension.
Drive Belts -Drive Belts - Visually check the belts and replace if Visually check the belts and replace if they are cracked or frayed.they are cracked or frayed.
Adjust belts that have a glazed or shiny surface which indicates belt slippage.Adjust belts that have a glazed or shiny surface which indicates belt slippage.
Correctly installed and tensioned belts will show even pulley and belt wear. ReferCorrectly installed and tensioned belts will show even pulley and belt wear. Refer
to Section 110-0030, ENGINE AND MOUNTING, in the Maintenance Manual forto Section 110-0030, ENGINE AND MOUNTING, in the Maintenance Manual for
drive belt tension and adjustment of new and used drive belts.drive belt tension and adjustment of new and used drive belts.
Front Brakes -Front Brakes -
Check pads and discs for Check pads and discs for wear and replace where necessary.wear and replace where necessary.
Note:Note:This service interval applies to normal This service interval applies to normal driving. Check more frequentlydriving. Check more frequently
under more severe conditions. Thickness of pad friction material should never beunder more severe conditions. Thickness of pad friction material should never be
allowed to wear below 3 mm (0.12 allowed to wear below 3 mm (0.12 in).in).
EVERY 1 000 HOURS OF OPERATIONEVERY 1 000 HOURS OF OPERATION
Hydraulic System Pressure Checks -Hydraulic System Pressure Checks -Check all steering, body and brakingCheck all steering, body and braking
system pressures.system pressures.
Note:Note:
Instructions for checking pressure, and locations of pressure check points,Instructions for checking pressure, and locations of pressure check points,
are contained in the relevant service manual sare contained in the relevant service manual section. If the pressures are outwithection. If the pressures are outwith
the specified settings then components in the relevant system the specified settings then components in the relevant system should beshould be
inspected, repaired or replaced to ensure the correct operation of the sinspected, repaired or replaced to ensure the correct operation of the system. Allystem. All
safety instructions in the relevant sections should be strictly safety instructions in the relevant sections should be strictly adhered to.adhered to.
Main Hydraulic Filter -Main Hydraulic Filter -
Clean filter housing and install new element.Clean filter housing and install new element.
Rear Disc Brake Filter(s) -Rear Disc Brake Filter(s) -
Replace filter element(s) when indicator sight gaugeReplace filter element(s) when indicator sight gauge
shows replacement is necessary, or after 1 000 hours of operation, whichevershows replacement is necessary, or after 1 000 hours of operation, whichever
comes first.comes first.
To Next Page
Loading...
