3-333-33
14901490
timed, preprogrammed schedule where in Second through Sixth gears thetimed, preprogrammed schedule where in Second through Sixth gears the
lockup clutch is disengaged only long enough to allow the torque converter’slockup clutch is disengaged only long enough to allow the torque converter’s
fluid coupling to absorb shift shock. Otherwise, the lockup clutch is engaged andfluid coupling to absorb shift shock. Otherwise, the lockup clutch is engaged and
no torque multiplication takes place in Second through Sixth gears.no torque multiplication takes place in Second through Sixth gears.
5. Manual Mode Switch -5. Manual Mode Switch - The manual mode facility is designed as a ServiceThe manual mode facility is designed as a Service
Technician facility to allow stall checks and clutch pressure checks to beTechnician facility to allow stall checks and clutch pressure checks to be
implemented by Service Personnel, and permit movement of the vehicle, ifimplemented by Service Personnel, and permit movement of the vehicle, if
necessary, to a repair area. With the manual mode switch in the 'On' position,necessary, to a repair area. With the manual mode switch in the 'On' position,
the body up interlock and hoist interlock pressure switch mechanisms arethe body up interlock and hoist interlock pressure switch mechanisms are
disengaged.disengaged.
WARNINGWARNING
This allows unauthorised selection of reverse or any This allows unauthorised selection of reverse or any forward gear withforward gear with
the body raised, constituting a safety hazard. Operators must not usethe body raised, constituting a safety hazard. Operators must not use
the manual mode facility when working the vehicle! It the manual mode facility when working the vehicle! It is recommendedis recommended
that the mode selection key is removed from the unit that the mode selection key is removed from the unit and retained in aand retained in a
safe place until required by Service personnel.safe place until required by Service personnel.
Note:Note:
The manual mode can only be used if the mode selection switch is in theThe manual mode can only be used if the mode selection switch is in the
Power position and the transmission is in neutral.Power position and the transmission is in neutral.
WARNINGWARNING
Do not operate engine for more than 30 seconds at full Do not operate engine for more than 30 seconds at full throttle withthrottle with
transmission in gear and output stalled as this wtransmission in gear and output stalled as this will result in severeill result in severe
overheat damage to the transmission.overheat damage to the transmission.
MANU
MANUAL AUTO AL AUTO POWEPOWER ER ECONOCONOMYMY
55
To Next Page
Loading...
