3-343-34
WARNINGWARNING
The manual mode is not intended to The manual mode is not intended to be used for normalbe used for normal
operations. The machine should only be driven at very low speeds inoperations. The machine should only be driven at very low speeds in
first or reverse gears if the manual mode is activated, or damage to thefirst or reverse gears if the manual mode is activated, or damage to the
transmission may result.transmission may result.
6. Manual Mode Warning Light -6. Manual Mode Warning Light -
This light is located on the front face of theThis light is located on the front face of the
CEC–2 interface box. The Manual Mode Warning Light illuminates to alert theCEC–2 interface box. The Manual Mode Warning Light illuminates to alert the
operator when the transmission has been switched to operate in the manualoperator when the transmission has been switched to operate in the manual
mode. The light should be 'Off' during normal operation.mode. The light should be 'Off' during normal operation.
7. Check Trans Warning Light -7. Check Trans Warning Light -Illuminates to alert of a minor fault in theIlluminates to alert of a minor fault in the
transmission shift system or abnormal transmission temperature. The warningtransmission shift system or abnormal transmission temperature. The warning
light will come 'On' when the ignition keyswitch is turned to position '1' to providelight will come 'On' when the ignition keyswitch is turned to position '1' to provide
a bulb and system check and should go 'Off' a few seconds after the engine isa bulb and system check and should go 'Off' a few seconds after the engine is
started and the transmission oil pressure rises.started and the transmission oil pressure rises.
The check trans warning light will come 'On' during operation if the ECU hasThe check trans warning light will come 'On' during operation if the ECU has
detected a minor fault in an electrical component or abnormal transmission oildetected a minor fault in an electrical component or abnormal transmission oil
temperature. If transmission oil temperature is too high, stop the machine, selecttemperature. If transmission oil temperature is too high, stop the machine, select
Neutral (N), and increase engine speed to allow a greater flow of oil to the oilNeutral (N), and increase engine speed to allow a greater flow of oil to the oil
cooler until oil temperature drops to normal operating range. In most cases, acooler until oil temperature drops to normal operating range. In most cases, a
minor fault triggering the check trans warning light will not prevent normalminor fault triggering the check trans warning light will not prevent normal
operation from continuing but, depending on the nature of the problem, the ECUoperation from continuing but, depending on the nature of the problem, the ECU
could take action to protect the transmission from damage, such as preventingcould take action to protect the transmission from damage, such as preventing
operation in high gear ranges. If the check trans warning light comes 'On', haveoperation in high gear ranges. If the check trans warning light comes 'On', have
the problem diagnosed and corrected at the earliest opportunity.the problem diagnosed and corrected at the earliest opportunity.
8. In-convertor Indicator Light -8. In-convertor Indicator Light -Illuminates when the transmission is in torqueIlluminates when the transmission is in torque
converter drive. It goes 'Off' when Lockup is engaged. In order to avoidconverter drive. It goes 'Off' when Lockup is engaged. In order to avoid
unnecessary waste of fuel, if traffic or other road conditions permit, the operatorunnecessary waste of fuel, if traffic or other road conditions permit, the operator
14811481
1
1
22
33
44
55
DD
NN
RR
11
RR
22
77
To Next Page
Loading...
