TERK Technologies FDTV1a - Attaching the Multi-Purpose Stand;Wall Mount

FDTV1a
Installation (continued)
3
Attaching the Multi-Purpose
Stand/Wall Mount
The Multi-Purpose Stand/Wall Mount attaches to
the FDTV1a two ways: to the back for laying flat or
mounting to the wall, or to the bottom for standing the
antenna upright.
To lay the FDTV1a flat or mount it to your wall:
1. Push the screws through the holes on the bottom of
the stand.
2. Line the stand up with
the holes on the back
of the antenna. Use a
Phillips-head screwdriver
to attach the stand to
the back of the antenna.
Make sure not to
overtighten the screws.