TERMA SCANTER 6002 - Warnings and Safety Instructions

3DJH
5HY(

6&$17(55DGDU6\VWHP
7HFKQLFDO0DQXDO
+7
 :DUQLQJVDQG6DIHW\,QVWUXFWLRQV
7KHIROORZLQJRXWOLQHVEDVLFZDUQLQJVDQGVDIHW\LQVWUXFWLRQVZKHQZRUNLQJRQWKH
UDGDUV\VWHP)XUWKHUZDUQLQJVDQGVDIHW\LQVWUXFWLRQVFDQEHIRXQGLQGRFQR
+7³:DUQLQJVDQG6DIHW\,QVWUXFWLRQVIRU7HUPD5DGDU$QWHQQD6\V
WHPV´
In no event, Terma A/S shall be held liable for any direct, indirect, punitive, incidental or consequential damages what-
so-ever arising out of or connected with the use or misuse of its products.
SAFETY
FIRST
WARNINGS,
CAUTIONS AND
SAFETY
INSTRUCTIONS
AUTHORIZED
PERSONNEL
ONLY
CAUTION
Radar safety sheet - 679071-QA Rev. B. 2018-apr-11. Prep.: MFB
High voltage may be present at several points of the equipment, even with equipment
switched off. Observe and follow all electrical safety precautions. These voltages may
cause injury or even death.
When maintaining the radar, the radar and instruments must be connected to the same
electrical protective ground.
Always use ESD (Electrostatic Sensitive Device) precautionary procedures when handling
ESD marked modules. The equipment contains components sensitive to damage by
electrostatic discharge. Wrist strap connected to earth bonding point must always be used
when handling unshielded electronics. Modules must be stored in static shielding packaging
(EIA-541). Module repair must be done on a ESD workstation, by qualified personnel.
Some equipment is heavy. To avoid injury, use proper lifting technique, 2 person lifting or
lifting aids.
For transceivers with magnetrons: Use only non-magnetic tools. Keep a distance of a
minimum of 40 cm from the modulator/magnetron, when transmitting with the door open.
RADAR SYSTEM MAINTENANCE
WARNING
Only access by authorized personnel.
This radar produces low power non-ionizing electromagnetic radiation. Radiation is normally
not dangerous for the human body, however precautions should be taken, and a safety
distance of 1 m from the antenna when operating should be kept.
Always disconnect power before maintaining the radar. The rotating antenna may cause
injury.
Always wear climbing harness when accessing a radar tower. Observe and follow local
safety regulations. Inform the relevant people of the work to be performed.
Part of the equipment may have hot surfaces. Precautions should be taken.
NON-IONIZING
)LJ :DUQLQJVDQGVDIHW\LQVWUXFWLRQV