termovana ANNA - Preliminary Operations; Pellet Loading; Electrical Power Supply

ENGLISH
ENGLISH
21
02/2021 - EN
11 PRELIMINARY OPERATIONS
11.1 PELLET LOADING
Therstoperationtobecarriedoutbeforeturning
theapplianceonistollthetankwithfuel(pellets),
preferably using a scoop.
 Becarefulnottotouchthehotpartsiffuelrelling
is carried out with the stove running.
Do not empty the bag directly into the tank to
avoid loading sawdust or other foreign elements
that could compromise correct functioning of the
stove and to avoid dispersing the pellets outside
the tank itself.
Be sure to close the lid of the tank well after loading
the pellets. The safety pressure switch (for models
withoutsideairintake)veriesproperclosure(g.
3.1) and sends an alarm if the lid is left open for
more than 20 seconds with the stove running.
11.2 ELECTRICAL POWER SUPPLY
Connect the stove to the mains power, operate the
ON switch on the back of the stove, positioning it
to“I”(g.3.2).Iftheconnectionisproperlymade,
the display will light up.
During long periods of non-use, it is recommended
to position the switch on the back of the machine
to OFF (O).
Do not touch the control panel when the stove is
being powered.
11.3 IGNITION
Before each ignition, make sure that the burn pot
is completely empty and correctly positioned in its
seat.
To turn on the stove hold the key pressed for a
few seconds.
Avoid manually turning on the stove if the automatic
ignition system is compromised.
During initial ignition of the stove it is possible to
generate unpleasant smells or fumes caused by
the evaporation or drying of some of the materials
used. This phenomenon will gradually disappear.
  Duringtherstlightings,werecommendthatyou
keep the premises well ventilated.
Do not pour pellets directly into the burn pot.

        
door is opened, avoid leaving it open for long
periods to prevent the closure sensor from
notifying the open door status with an acoustic
alarm.
11.4 POWER OFF
Toturno󰀨thestoveholdthe key pressed for a
few seconds.
It is advisable to wait for the stove to completely
cool before re-igniting it again.
 Thestoveshouldalwaysbeturnedo󰀨strictlyin
accordance with the above, and absolutely not by
disconnecting it from the mains power.
- 3.2 -
11.5 OPERATION WITH AMBIENT PROBE
ON STOVE
Thestovecanbeswitchedon/o󰀨manuallyorina
programmed way.
The stove modulates the power depending on
the ambient temperature measured by the on-
board probe (that is, the stove tries to maintain
the desired temperature, consuming as little as
possible).
If the user has enabled the “Standby” function,
       󰀨
when the set temperature is reached, then
re-ignite when the ambient temperature falls
below the set delta.
The desired ambient temperature can be set using
the keys
.
ATTENTION: Do not insert fuel through the
aeration outlets.
- 3.1 -