Setting up the hardware and installing drivers.
The following sections describe how to connect your Cinergy T² to your computer and install
the drivers. Connecting the included rod antenna is the final step of the installation.
Connecting to the USB 2.0 port.
1. Connect the mini USB plug of the included cable to the USB socket of the Cinergy T².
2. Boot your computer and wait until the operating system has loaded completely.
3. Connect the other end of the USB cable to a free USB 2.0 port on your computer.
4. Continue with the installation of the correct drivers for your operating system.
Installing the drivers in Windows 2000 (Service Pack 4)
If you have not already done so, place the enclosed installation CD into your CD-ROM drive.
A. Windows 2000 will recognize the new device and will launch the hardware installation
wizard. Click “Next”.
B. In the appearing dialog window, select the “Search for a suitable driver for my device
(Recommended)” item. Click “Next”.
C. Select the option “CD-ROM drives” and deselect all other sources. Click “Next”.
D. Windows 2000 will automatically find the correct driver on the installation CD. Confirm by
clicking “Next”.
E. In the following dialog box, Windows will inform you that the digital signature was not
found for the driver. Click “Continue”.
F. Conclude the installation by clicking “Finish”.
This completes the installation of the drivers and you can now start installing the application
programs.
Cinergy T² Hardware (English) 11
To Next Page
Loading...
Need help?
General
