EMERGENCY RESPONSE GUIDE
11
CUTTING THE FIRST RESPONDER LOOP
STEP 1: Open the hood (also known as the Front Trunk). See page 21
for details.
The cut loop is located on the passenger side. Its label protrudes
from under the plastic access panel.
Cut loop
label
Remove
access
panel
DISABLING HIGH VOLTAGE
STEP 2: Remove the access panel by pulling its rear edge upward to
release the five clips that hold it in place. Maneuver it toward the
windshield to remove.
Double
cut the
loop
STEP 3: DOUBLE CUT the loop to remove an entire section.
Removing an entire section of the cut loop eliminates the risk of
the wires accidentally touching (reconnecting).
WARNING: Regardless of the disabling procedure you use, ALWAYS ASSUME THAT ALL HIGH VOLTAGE COMPONENTS ARE ENERGIZED! Cutting, crushing or touching high voltage
components can result in serious injury or death.
To Next Page
Loading...
