Tesla 3 2018 - Seat Heaters; Seat Covers

Raising/Lowering the Rear Center Head
Support
To raise the head support, lift it until you hear
it click into place. Push down on the head
support to ensure that it is secure.
To lower the head support, press and hold the
button on the outer base of the right post and
press the head support down.
Removing/Installing the Rear Center Head
Support
To remove the head support:
1. Raise the head support (see Raising/
Lowering the Rear Center Head Support
on page 20).
2. Press and hold the button on the outer
base of the right post.
3. Insert a short,
flat object (such as a small
flat head screwdriver) into the opening on
the inside base of the left post and pull
the head support upwards.
To install the head support:
1. With the front of the head support facing
forward, insert both posts into the
corresponding holes on the backrest.
2.
Press down on the head support until you
hear it click into place.
3. Pull up on the head support to ensure that
it is secure.
Warning: Ensure that the head
support is installed properly before
anyone occupies the rear center seat.
Failure to do so increases the risk of
injury or death if a collision occurs.
Seat Heaters
The front and rear seats are equipped with
heating pads that operate at three levels from
3 (highest) to 1 (lowest). To operate the seat
heaters, see Operating Seat Heaters on page
87.
Warning: To avoid burns resulting from
prolonged use, individuals who have
peripheral neuropathy, or whose capacity
to feel pain is limited because of diabetes,
age, neurological injury, or some other
condition, should exercise caution when
using the climate control system and seat
heaters.
Seat Covers
Warning: Do not use seat covers in Model
3. Doing so could restrict deployment of
the seat-mounted side air bags if a
collision occurs. It can also reduce the
accuracy of the occupant detection
system.
Front and Rear Seats
20 Model 3 Owner's Manual