Starting
When you open a door, Model 3 powers on the
touchscreen and you can operate all controls.
To drive Model 3:
1. PRESS THE BRAKE PEDAL - Model 3
powers on and is ready to drive.
2. SELECT A GEAR - Move the gear lever all
the way down for Drive and all the way up
for Reverse. See Shifting Gears on page
41.
Everything you need to know when driving
Model 3 displays on the touchscreen.
Drive Disabled - Requires Authentication
If Model 3 does not detect a key when you
press the brake (an authenticated phone is not
detected, or 30 seconds has passed since you
used the key card), the touchscreen displays a
message telling you that driving requires
authentication.
If you see this message, place the key card
behind the cup holders on the top of the
center console where the RFID transmitter can
read it. The 30 second authentication window
restarts and you can start Model 3 by pressing
the brake pedal.
A number of factors can aect whether Model
3 can detect an authenticated phone (for
example, the phone's battery is low or dead
and is no longer able to communicate using
Bluetooth).
Always keep your authenticated phone and a
key card with you. After driving, your
authenticated phone or key card is needed to
restart Model 3 after it powers
o. And when
you leave Model 3, you must bring your
authenticated phone or key card with you to
lock Model 3, either manually or automatically.
Powering
O
When you finish driving, shift into Park by
pressing the button on the end of the gear
selector. The parking brake automatically
engages and all systems keep operating.
When you leave Model 3 with your
authenticated phone and key card, it powers
o automatically, turning o the touchscreen.
Model 3 also powers
o automatically after
being in Park for 15 minutes, even if you are
sitting in the driver’s seat.
Although usually not needed, you can power
o Model 3 while sitting in the driver’s seat,
provided the vehicle is not moving. Touch
Controls > Safety & Security > Vehicle
Power > Power
O. Model 3 automatically
powers back on again if you press the brake
pedal or touch the touchscreen.
Note: Model 3 automatically shifts into Park
whenever it is determined that you are exiting
the vehicle, even when you shift into Neutral
before exiting. To keep Model 3 in Neutral, you
will need to activate Transport Mode (see
Instructions for Transporters on page 141).
Restarting the Touchscreen
If your touchscreen is unresponsive or
demonstrates unusual behavior, restart it by
shifting into Park then pressing and holding
both scroll buttons on the steering wheel until
the touchscreen turns black, releasing when
the Tesla logo appears. Within approximately
30 seconds, the touchscreen restarts. If the
touchscreen is still unresponsive or
demonstrating unusual behavior, contact
Tesla.
Note: Restarting the touchscreen does not
power Model 3 o and on.
Warning:
Paying attention to road and
trac conditions must always be the
driver's highest priority. To ensure the
safety of vehicle occupants as well as
Starting and Powering O
Driving 39
To Next Page
Loading...
