7
ENG
USING THE APPLIANCE
About the control panel
On/Off
Filter Reset
Speed
Auto modeAuto mode
Timer
Air Quality & Light
1. Put the plug in the wall socket
All lights go on once and you hear a beep.
Then the lights go out again.
2. Press the power button to switch on the appliance.
The power
lights, AQ light on and FAN SPEED 2 light (Medium) on the control panel go on.
3. Fan speed adjustment
The fan speed light indicates at which fan speed the appliance is operating.
Press Speed
button to adjust fan speed level, there are three levers 1~3 refers to Low, Medium and High
level.
4. Auto mode
At Auto mode, the fan speed will be automatically adjusted according to AQI level as below:
AQ Color Blue Green Orange Red
Speed mode Sleep 1 (Low) 2 (Medium) 3 (High)
AQ level Very good Good Unhealthy Hazardous
5. Sleep mode
When you use the appliance in Sleep mode, it works very quietly, only the
and buttons light on, all
other buttons light off, press any other buttons (except
and buttons ) to exist the sleep mode.
6. AQ Light
Working status (Air quality light)
The air quality light color will automatically change according to the detecting result of sensor.
Standby status (Night light mode)
1. At standby status, press
button, the amber night lights (orange) will turn on.
2. Press
button again, the light become half brightness, to turn off the night light, just press the button
third time, the light cycles as Brightness, Half brightness, Off.
To Next Page
Loading...
Need help?
General
