10
ENG
Filter replacement force mode
STORAGE
ENVIRONMENT
TROUBLESHOOTING
When using the air purifier in an environment of heavy pollution, the lifespan of the air filter may be
significantly reduced. You can change the filters even if
does not light up. Follow the steps below to
perform a hard reset.
1. Replace the air filters as mentioned in the Filter Replacement section.
2. Plug in the air purifier and keep in standby mode.
3. Press and hold
for 3 seconds, and it will light up.
4. Press and hold
again for 3 seconds, and it will turn off. The reset is now complete.
Unplug the power cord, then wipe the machine clean, put the appliance in the packing bag ,then put it in a
dry place away.
Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an
official collection point for recycling. By doing this, you help to preserve the environment.
This chapter summarises the most common problems you could encounter with the appliance. If you are
unable to solve the problem with the information below, contact the Consumer Care Centre in your country.
Problem Cause Solution
Air purifier does not
power on.
Unit is not plugged into an
electrical outlet.
Connect the plug to a powered electrical
outlet.
Outlet is not working properly.
Try plugging the air purifier into a different
outlet.
Power button has not been
pressed after plugging in the air
purifier.
Press
once to turn on the air purifier.
Power cord is damaged.
Immediately discontinue use and contact
Customer Support
Air purifier is defective or
malfunctioning.
Air purifier does not
respond to button
Air purifier is not plugged into
an outlet.
Connectthe plug to a powered electrical
outlet.
Air purifier is defective or
malfunctioning.
Immediately discontinue use and contact
Customer Support.
To Next Page
Loading...
Need help?
General
