Step1 Highlight Satellite and press ENTER to access the satellite list and select one.
Step 2 Highlight LNB Type and press ENTER to select the LNB type.
Step 3 Make sure the 22KHz, DiSEqC1.0/1.1 switch is corresponding to the selected satellite.
After the above steps are finished, press the blue button to search for channels.
DVB-T/ DVB-C/ATV
Select “Auto Tuning” to search the programs automatically. Before searching, you may need to
select the country or tuner mode. If you want to stop the auto search, press MENU button or
EXIT button, a exiting dialog is popped out.
• Press to confirm exit.
• Press to continue searching.
DTV Manual Tuning
Search and store programs manually.
DVB-T/ DVB-C
In DVB-T mode, select DTV manual tuning and press ENTER to access the searching interface,
then press left and right buttons to search the programs manually.
1. Press or to select a channel No., highlight Search and then press ENTER to start the
search.
2. The search stops when a program is found and this program will be stored in the current
channel position. If you want to stop the search, press MENU button.
In DVB-C mode, select “DTV manual tuning”, then select “Search” to search the
programs manually.
ATV Manual Tuning
In ATV mode, select ATV Manual Tuning and press ENTER button to access.
Highlight and press or to select Storage To 1 (maybe other number),TV System and
channel No.. Then select search and press ENTER to start the search.
•Press for the unit to search towards higher frequency;
•Press for the unit to search towards lower frequency;
3. When a program is found, press the red button to stored it at the current channel position.
If you want to stop the search, press MENU button.
Figure 1
To Next Page
Loading...
Need help?
General
