11
Step Three - Prepare for Installation
1 Using a T20 Torx driver, remove the two
security screws from the bottom of the
High Power Wall Connector.
2 Release the front cover by pulling it
towards you far enough to disconnect the
ribbon cable. Disconnect the ribbon cable
from inside the main enclosure to fully
release the front cover.
CAUTION: When removing the front
cover, do not damage the ribbon
cable. Disconnect the ribbon cable before
fully releasing the front cover.
3 Disconnect the ground wire from the
terminal block and push it out of the way
to avoid damaging it when completing the
next step.
4 Use a 1 1/4” (32 mm) hole saw to remove
the power entry knock-out from either the
side or back of the connector.
CAUTION: When using the hole saw,
do not damage internal components.
If using the side knock-out, center the hole
saw at the indented hole and drill through
all layers. After drilling, use a sharp knife or
razor to cut and remove the rubber
molding, as indicated by the indentations
in the rubber.
NOTE: Use the back knock-out when
mounting to a pedestal or when running
wires from behind a wall.
5 Reconnect the ground wire to the terminal
block.
Side knock-out Back knock-out
HPWC_Install_Guide.book Page 11 Wednesday, April 2, 2014 3:30 PM
To Next Page
Loading...