3. On top of the low voltage battery, lift the
locking tab that attaches the electrical
connector to the connector housing.
NOTE: The appearance of the electrical
connector and connector housing may
vary, but the procedure remains the same.
4.
On top of the low voltage battery, pull the
connector housing to the left. The
electrical connector releases from the
low
voltage battery.
5.
Release the cover from the red positive
(+) jump post, and then connect the low
voltage power supply's red positive (+)
cable to the red positive (+) jump post.
CAUTION:
To avoid damaging
Model X, do not allow the positive
cable to contact other metal
components.
6. Connect the
low voltage power supply's
black negative (-) cable to the vehicle in
the location shown.
7.
Turn on the external power supply (refer
to the manufacturer’s instructions). Touch
the touchscreen to wake it up.
NOTE: It may take several minutes to
receive enough power to wake up the
touchscreen.
8. When external low voltage power is no
longer required, disconnect both cables,
beginning with the black negative (-)
cable.
9. On top of the low voltage battery, push
the connector housing towards the
electrical connector so that the electrical
connector engages the
low voltage
battery.
10. On top of the low voltage battery, push
down the locking tab that attaches the
electrical connector to the connector
housing.
11. Replace the maintenance panel by placing
it back in its original location and pressing
down until it is secure.
12. Close the hood.
Instructions for Transporters
251Roadside Assistance
To Next Page
Loading...
