Tesla MODEL X - Page 183

WARNING: Never exceed the speed rating of your
vehicle's tires. The speed rating is shown on the
sidewall of your tires (see Understanding Tire
Markings on page 202) .
Asymmetric Tires
Model X tires are asymmetric and must be mounted on
the wheel with the correct sidewall facing outward. The
sidewall of the tire is marked with the word
OUTSIDE.
When new tires are installed, make sure that the tires are
correctly mounted on the wheels.
WARNING: Road holding is seriously impaired if
the tires are incorrectly installed on the wheels.
Removing and Installing Aero Covers
If your Model X is equipped with aero covers, you must
remove them to access the lug nuts.
To remove an aero cover:
1.
Grasp the aero cover firmly with both hands.
2.
Pull the aero cover toward you to release the
retaining clips.
To install an aero cover:
1.
Align the aero cover into position so that the notch at
the base of the Tesla "T" is aligned with the tire's
valve stem.
2.
Push firmly around the perimeter of the aero cover
until it fully snaps into place.
For Gemini wheels, press on the perimeter of the
cover until it aligns with the wheel surface. Press on
the Tesla “T” in the center until the cap snaps into
place. See
Parts and Accessories on page 193 for
more information.
CAUTION:
To prevent the aero cover from
falling o, ensure that it is fully secured before
driving.
Removing and Installing Lug Nut Covers
If your Model X is equipped with lug nut covers, you
must remove them to access the lug nuts.
To remove a lug nut cover:
1. Insert the curved part of the lug nut cover tool
(located in the glovebox in some vehicles, or you can
use a small allen wrench) into the hole at the base of
the Tesla "T.
NOTE: The lug nut cover tool can also be purchased
at an auto parts store or through online retailers.
2.
Maneuver the lug nut cover tool so that it is fully
inserted into the hole in the lug nut cover.
3.
Twist the lug nut cover tool so that the curved part is
touching the middle of the lug nut cover.
4.
Firmly pull the lug nut tool away from the wheel until
the lug nut cover is released.
To install the lug nut cover:
1. Align the lug nut cover into position.
2.
Push firmly on the lug nut cover until it fully snaps
into place.
CAUTION:
Make sure the lug nut cover is fully
secure before driving to prevent it from falling
o.
Tire Care and Maintenance
181Maintenance