Tesla RoboStar T10 - Page 28

If the mop is dirty after cleaning, you can clean it with lukewarm water. When removing the mop
from the holder, make sure you do not damage the velcro fastener on the bracket quickly.
Dampen mop lightly with water for faster and smoother wiping.
1
Water container opening cover
3
Opening for moistening the mop
2
Handle for removing the container
from the vacuum cleaner
4
Water container opening
 Water should slowly drip from the left and right plastic parts.
 Press the top cover of the vacuum cleaner gently to open it, remove the dust container and
insert the water container instead.
 The container should be properly inserted into its place in the vacuum cleaner.
 Close the top of the vacuum cleaner.
 Press the "CLEAN" button to start the wet mopping operation.
 In this mode, the device does not vacuum, only the side brushes operate.
 Water drips automatically, so do not let the vacuum cleaner stand motionlessly in one place
with remaining water in the container to prevent water spillage on the floor.
 Do not use the microfiber cloth for mopping uneven surfaces or carpets.
 Remove the water container when the mopping is done.
 Do not charge the battery with the water tank for safety reasons.
DESCRIPTION OF THE STATUS LED DIODES
Status
CLEAN button
Charging
Flashing (orange colour)
Battery fully charged
Light is on (green colour)
Low battery
Light is on (orange colour)
Selected mode
Flashing (green colour)
Error
Flashing (red colour)
DESCRIPTION OF AUDIO ERROR SIGNALS
Short tone
Cause
Solution