Tesla VCR600W - Installation

8
INSTALLATION
1. Connect power line and feed the excess wire into the slot
3. Please do not move the charging base arbitrarily and keep it out of direct sunlight
4. Installation of side brush
Make the left side brush (L) and the right side brush (R) correspond to L and R on the
bottom casing, press L and R and the side brushes are installed till you hear a “cracking”
sound
2. Place charging base against the wall and connect the power
• Ensure a space of above 0.5m on both sides of the charging base and a space of
above 1.5m in the front
• If the power line is vertical to the ground, it may be dragged by the host and
consequently the charging base may be powered off
• The charging indicator is normally on when powered on and off when charged
• If the charging base is relocated, the host may fail in positioning and lose the map.
When restarted, the host will rebuild and memorize the map and the rebuilt map may
lose cleaning information of forbidden areas and other areas
• Direct sunlight will interfere with recharging signal and consequently the host may be
unable to return to the charging base
NOTE
NOTE