5
ENG
INSTALL WASHING MACHINE
Removal of transport bolts
• In order to prevent internal damage to the machine during transportation, 4 transport bolts are installed
on the back of the machine.
• Please be sure to remove the transport bolts before using the washing machine. If not, strong vibration,
noise and failure may occur.
• If you need to transport the washing machine, please be sure to reinstall the transport bolts to prevent
damage to the inside of the machine during transportation.
1. Loosen the
transport bolt
counterclockwise
with a wrench until
iti is loose ang
falling off.
2. Pull out the
transport bolt.
3. Cover the transport
bolt hole plug.
Leveling of the washing machine
• Do not place the washing machine outdoors or in a place where the ambient temperature is lower than
0°C; it cannot be placed on a carpet or wooden floor; it should be placed on a firm and flat ground with
an inclination angle of less than 10°.
• If the washing machine is unstable due to the uneven ground, the adjustable feet at the bottom of the
washing machine can be adjusted to keep the washing machine stable.
• During the adjustment process, pressure is applied to the diagonal line of the top cover of the washing
machine. If the washing machine shakes, the adjustable feet must be readjusted.
The provided water hose may differ depending on the model.Please follow the instuction according to the
provided water hose.
Lock nut
Leveling feet
Wrench
Leveling feet
close to the
ground
Lock nut
Leveling feet
Wrench
1. Loosen the lock nuts above the rubber feet,
and adjust the height of 4 adjustable feet to
make the feet close to the ground smoothly
without shaking.
2. After leveling, adjust the nuts above
the 4 rubber feet with a wrench to
lock the 4 adjustable feet.
To Next Page
Loading...
