TESLICA M1H - Page 9

www.teslica.com 9
3.6 INSTALLATION OF HEADLIGHT
AND FRONT FENDER
1. Use wrench to remove 3 bolts from
suspension frame
2. Align the top center bolt through the
fender and headlight eyelet
3. Tread back into suspension frame and
tighten with wrench. Adjust alignment
4. Align and tighten side wire fender
supports with wrench and screwdriver
3.7 INSTALLATION OF BELL, BOTTLE
HOLDER AND REFLECTORS
1. Bell: Remove screw, open base and
afx on handle bar. Replace and tighten
screw.
2. Bottle holder: Remove 2 screws, align
bottle holder, replace and tighten screws
3. Reectors: Remove 1 screw, open base
and afx red one on seat post and white
one on horizontal section of gooseneck.
Replace and tighten screws. Adjust
reector angle