PULLER-TENSIONER
Model: AFS303
Manual: MI-AFS303-320-00-GB
4.16 END OF THE OPERATIONS 20
5. INSTRUCTION FOR USE – CONNECTED MACHINES 21
5.1 GENERAL ASPECTS 21
5.2 MACHINES SET-UP 22
5.3 CONNECTED MACHINES OPERATIONS 23
5.4 PULL CONTROL SETTING 23
5.4.1 PULL LIMITING DEVICE SETTING 23
5.4.2 PULL PROGRAMMING DEVICE SETTING 23
5.5 USING OF ELECTRONIC SPEED SYNCHRONIZER DEVICE (OPTIONAL) 24
5.6 ROPE LOCKING CLAMP (OPTIONAL) 24
5.7 ALARM CONDITION WHEN USING CONNECTED MACHINES 24
5.7.1 STRINGING LENGTH ERROR 24
5.7.2 SWITCH ON THE MACHINE WITH CONTROL NOT IN NEUTRAL 24
5.7.3 EMERGENCY STOP 25
5.7.4 CAN-BUS DIS-CONNECTION BETWEEN THE MACHINES 25
5.7.5 ROPE-CLAMP POSITION 25
5.7.6 GEAR-BOX LOW-PULL POSITION 25
5.7.7 CONNECTION MACHINE SELECTOR 25
5.7.8 COMPONENT FAULT 25
6. SAFETY CONDITIONS 26
6.1 SAFETY DEVICES 26
6.2 EMERGENCY STOP DEVICE 26
6.3 PERIODIC OPERATIONS 26
6.4 RESIDUAL RISKS 27
7. MAINTENANCE 28
7.1 GENERAL PRESCRIPTIONS 28
7.2 LEVELS CONTROL 28
7.3 TYRES INFLATION PRESSURE 28
7.4 SUGGESTED LUBRICANTS 28
7.5 ENDOTHERMIC ENGINE MAINTENANCE 28
7.6 HYDRAULIC CIRCUIT MAINTENANCE 29
7.7 REDUCTION GEAR MAINTENANCE 29
7.8 RADIATOR’S MAINTENANCE 30
7.9 GREASING 30
7.10 OTHER PERIODIC OPERATIONS 30
7.11 SUMMARY TABLE FOR ORDINARY MAINTENANCE 30
8. HOW TO DISABLE THE MACHINE 31
8.1 TRANSPORT 31
8.2 EXTENDED SERVICE STOP 31
8.3 STRIPPING 31
9. ENCLOSED DOCUMENTS 32
9.1 TABLES 32
9.2 SYSTEMS 32
9.3 OTHER DOCUMENTS 32
To Next Page
Loading...
