The data loggers have the defaults below:
* testo 175-T3: T/C -Type “K” programmed
testo 175-S1: “0 to 10V” programmed
testo 175-S2: “0 to 10V” programmed
The data logger with the above factory defaults can be used
immediately.
If you wish to use other measurement criteria, you will have to
program your data logger in accordance with your requirements
using testo ComSoft software (See
7. Programming
, P. 14).
External probes can be attached to many of the data loggers (See
6. CConnecting pprobes
, S. 13).
33.. IInniittiiaall ooppeerraattiioonn
8
Type
175-T1 175-T2 175-T3 175-S1 175-S2 175-H1 175-H2
Start ccriterion
Key start
Measuring rrate
5 min. 5 min. 10 s 1 s 1 s. 1 min. 1 min.
Stop ccriterion
Wraparound memory Until memory is full Wraparound memory
Alarm vvalues
Respective measuring range full-scale values (See Technical data)
Display
On - On - On
LEDs
Status led (green): Off / Alarm led (red): On
Measurement cchannels
All channels switched on*
Fast pprinter //
Stop: Switched on
data ccollector ffunction
New programming: Switched on
Protocol nname
testo175-{Type}_{Serial number}
To Next Page
Loading...
Need help?
General
