TESTO 926 - Commissioning; Battery;Rechargeable Battery Insertion; Radio Module Insertion

27
4. Commissioning
This chapter describes the steps required to commission
the product.
²
Removing tthe pprotective ffilm oon tthe ddisplay:
i Pull the protective film off carefully.
²
Inserting aa bbattery/rechargeable bbattery:
1 To open the battery compartment on the rear of the
instrument, push the lid of the battery compartment in
the direction of the arrow and remove.
2 Insert a battery/rechargeable battery (9 V monobloc).
Observe the polarity!
3 To close the battery compartment, replace the lid of
the battery compartment and push it against the
direction of the arrow.
- The instrument switches itself on and configuration
mode is opened.
4 Set the date, time and unit of measurement.
º See the chapter PERFORMING SETTINGS, objectives
SETTING THE DATE/TIME and following.
²
Inserting aa rradio mmodule ((accessory ppart):
Radio probes may only be used in countries in which
they have been Type Approved (see application infor-
mation of the radio probe).
 The instrument is switched off.
1 To open the radio module compartment on the rear of
the instrument, push the clip lock downwards and
remove the lid of the radio module compartment.
2 Insert the radio module.
3 To close the radio module compartment, replace the
radio module compartment and close it.
deenfresitptsvnl????
4. Commissioning