EasyManuals Logo

TESTO 926 User Manual

TESTO 926
21 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
34
6. Measuring
This chapter describes the steps that are required to
perform measurements with the product.
The instrument is switched on and is in measurement
view.
²
Taking aa mmeasurement:
i Put the probe in position and read off the readings.
With the Auto Hold function on:
The Auto Hold function is only active on plug-in
measuring probes.
- Auto Hold flashes during measurement.
- If the reading is stable within the set evaluation
time, a signal tone is given and the reading is
recorded.
i Start measurement again with .
With the alarm function on and if the alarm threshold
is exceeded or not undershot:
- Alarm lights up and a signal tone is given.
- The alarm goes out if the reading goes below the
upper or above the lower threshold again.
²
Changing tthe mmeasurement cchannel ddisplay:
You can change between displaying plugged-in probes
and radio probes ( ).
i To change the display: Press .
²
Holding tthe rreading, ddisplaying tthe mmaximum/minimum
value:
The current reading can be recorded. The maximum and
minimum values (since the instrument was last switched
on) can be displayed.
6. Measuring

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TESTO 926 and is the answer not in the manual?

TESTO 926 Specifications

General IconGeneral
BrandTESTO
Model926
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals