Need help?Do you have a question about the TESTO Saveris T2D radio probe and is the answer not in the manual?
General| Brand | TESTO |
|---|---|
| Model | Saveris T2D radio probe |
| Category | Measuring Instruments |
| Language | English |
Provides critical safety instructions for handling and operating the testo Saveris system.
Lists the minimum hardware, operating system, and software requirements for the testo Saveris system.
Step-by-step guide for installing the testo Saveris software on a computer.
Instructions for the initial setup and configuration of the Saveris system hardware.
Guide on how to integrate a Saveris router to optimize radio communication.
Procedure for assigning a static IP address to the Saveris base for Ethernet components.
Instructions for connecting and integrating Saveris Ethernet probes into the system.
Guide on using the startup wizard to commission new Ethernet probes.
Instructions for integrating a Saveris converter to manage signal conversion.
Details on how to perform a test run to ensure the proper operation of the measuring system.
Instructions for setting up system, probe, and channel alarms within the Saveris software.
Procedures for calibrating and adjusting probes to ensure measurement accuracy.
Instructions for updating the software and firmware of the Saveris system.
To Next Page