Need help?Do you have a question about the TESTO Saveris H2D radio probe and is the answer not in the manual?
General| Measurement range humidity | 0 to 100 %RH |
|---|---|
| Resolution | 0.1 °C / 0.1 %RH |
| Radio frequency | 868 MHz |
| Protection class | IP54 |
| Accuracy temperature | ±0.5 °C (-20 to +50 °C) ±0.8 °C (Remaining Range) |
| Accuracy humidity | ±3 %RH (10 to 90 %RH) ±5 %RH (Remaining Range) |
| Radio range | Up to 300 m in open space |
Explains symbols, writing standards, and general use.
Details safety precautions for operation, maintenance, and environmental protection.
Describes application areas, system requirements, and basic functionality of the testo Saveris system.
Details front/rear components and interfaces of the Saveris base.
Explains radio probes, Ethernet probes, routers, converters, and analog couplers.
Guides through initial setup, including flowchart, SIM, USB, power, and probes.
Explains integrating routers, converters, and analog couplers into the system.
Explains the importance and procedure of performing a test run and system checks.
Details procedures for mounting the Saveris base and probes.
Overview of the testo Saveris software interface, menus, and commands.
Guides on managing zones, configuring alarms, and analyzing data.
How to configure system settings and generate reports.
Overview of maintenance, component replacement, logging, and battery changes.
Procedures for calibration, adjustment, and software/firmware updates.
Provides technical specifications for Saveris base, probes, routers, etc.
Troubleshooting common issues and understanding Saveris base alarm messages.
Lists available accessories and spare parts with their article numbers.
To Next Page