5 First steps
40
5.9. Starting up hardware
Use the installation instructions when starting up the system for the
first time.
The following requirements must be fulfilled for the rest of the
startup process for the hardware:
• the Saveris base is ready for operation,
• all probes are registered on the Saveris base,
• the Saveris software is installed,
• a project has already been created and
• measurement operation has been ended.
1. Connect the Saveris base via the USB or network cable to the
computer on which the Saveris client is installed.
For continuous operation of the system, it is
recommended that the Saveris base be connected to
the computer via an Ethernet cable.
- The startup wizard starts.
2. Click on [Continue >].
- The configuration data of the Saveris base are shown.
To Next Page
Loading...
