Lid
LED Light Assembly
Base
Filter
Cartridge
Filter
Housing
Suction
Cup
Micro Filter Assembly
Power Supply
B. Remove Filter Cartridge
from package and rinse.
C. Insert Filter Cartridge
into Housing.
NOTE: Replace Filter Cartridge
every 2 to 3 weeks for optimal
sh health.
D. Make sure Pump is rmly
attached to Housing.
Water Level
at Filter Lip
Spillway
B. Add water and
Tetra AquaSafe
®
Plus.
Room
Temperature
A. Place Lid on Aquarium. Use cutouts in Lid for
Filter and LED Light Clamp. B. Plug the Filter and
LED Light into power outlet.
Always: Make a
Drip Loop (for safety).
LED Light Switch
(I) ON - (O) OFF
Pump
Motor
Thumb
Screws (2)
A. Using the adjustable Filter
Hanger and Suction Cup
attach Micro Filter Assembly
inside Aquarium, 1/2 inch
below the Aquarium Lid.
C
B
B
D
Impeller Well
Impeller
Impeller
Cover
Power Cord
Filter Lip
Spillway
(Adjustable)
Filter
Hanger
Clamp
A. Hang LED Clamp on back of Aquarium with at surface
facing into Aquarium. Insert thumbscrews into clamp to
secure. DO NOT over tighten.
A. Fill Aquarium
with gravel and
décor.
C. Insert Power Supply
Cord into jack on bottom
of LED light. Jack is visible
from underside and should
be outside of Aquarium.
B. Insert LED Light
into the Clamp.
Never: Run the lter
without water in it.
Back View
Lid
Base
LED Light
Light Switch
A
NOTE: DO NOT move aquarium
after it is lled with water.
Cord
Clip
Cord
Clip
A
C
Front View
Power
Supply Cord
Filter Power Cord
C. Water level should be
at the Filter Lip Spillway.
1
2
3
5
Start Here - Crescent 3 & 5 Gallon Aquarium System
Quick Setup Guide
Parts Check
Prepare Aquarium
Filter Setup
Start Your System
01/12 29002_901
For questions and concerns contact Customer Support 800.526.0650 • www.tetra-sh.com
Install LED Light
4
© 2012 Tetra Holding (US), Inc.
Tetra®, AquaSafe® are registered trademarks
29002_901TCrescent3&5gQSUG.indd 1 1/30/12 11:38 AM
To Next Page
Need help?
General
