APPLIANCE
APPLIANCE
AQUARIUM
POWER
CORDS
DRIP LOOP
DANGER: Since water is employed in the use of aquarium equipment, special care
should be taken to avoid electric shock. For each of the following situations, do not
attempt to repair the appliance yourself. Return it to an authorized service facility
for service, or discard it.
1. A. If the appliance falls into the water, do not reach for it.
First unplug it and then retrieve it.
B. If electrical components of the appliance get wet,
unplug the appliance immediately.
C. Carefully examine the appliance after installation.
It should not be plugged in if there is water on parts
not intended to get wet.
D. Do not operate any appliance if it has a damaged cord
or plug, if it is malfunctioning, or if it has been dropped
or damaged in any manner.
E. To avoid the possibility of water dripping onto the
appliance plug or outlet, position aquarium stand and
tank to one side of a wall-mounted outlet. A “drip loop” (see illustration) should
be arranged for each cord connecting an aquarium appliance to an outlet. The
“drip loop” is the part of the cord below the level of the outlet (or extension cord
connector) that prevents water from traveling along the cord to the outlet. If the
plug or outlet gets wet, do not unplug the cord. Disconnect the fuse or circuit
breaker that supplies power to the appliance. Then unplug the appliance and
examine the outlet for presence of water.
2. Close supervision is necessary when any appliance is used by or near children.
3. To avoid injury, do not contact moving parts or hot parts such as heaters, reectors,
lamp bulbs, etc.
4. Always unplug an appliance from an outlet when it is not in use, before putting on
or taking off its parts, and before cleaning it. Never yank cord to pull plug from outlet.
Grasp the plug and pull to disconnect.
5. If an extension cord is necessary, a cord with a proper rating should be used. A cord
rated for fewer amperes or watts than the appliance rating may overheat. Care
should be taken to arrange the cord so that it will not be tripped over or pulled.
6. Do not use an appliance for other than its intended use. The use of attachments not
recommended or sold by the appliance manufacturer may cause an unsafe condition.
7. Do not install or store the appliance where it will be exposed to the weather or to
temperatures below freezing.
8. Make sure the appliance is securely mounted on aquarium before operating it.
KEY ITEM DESCRIPTION MODEL SIZE
1 Clear Lid 29051-00
2 AC Low Voltage Adapter Plug 29054-00
3 Filter Assembly 25846-00
4 LED Light with White LEDs 29052-00
GloFish
®
Replacement LED Light
5 LED Light with Blue LEDs 29053-00
Parts Diagram & Identication
Replacement Parts List
For questions or missing parts
contact customer service at
(800) 526-0650 • www.tetra-sh.com
M-F 7:30 A.M. to 5:30 P.M. Eastern Time
© 2011 Tetra Holding, Inc.
1
LIMITED WARRANTY: Within one year from the date of original purchase,
we will repair or replace, at our option, any LED Aquarium Kit which is deemed
defective in workmanship or materials. This includes: Cube, Base, LED Light,
AC Adapter, and Filter Housing.
If the LED Aquarium Kit is found to be defective, and has not been modied,
damaged or misused, please return the unit with a copy of the receipt and
proof of date of purchase: Call (800) 526-0650 for return authorization and
shipping address.
Damage or injuries resulting from improper installation, negligence or misuse
are expressly not covered by this warranty. Incidental or consequential
damages are specically excluded.* Fish loss, personal injury, property loss or
damage resulting from use of these products are not covered by this warranty.
Incidental or consequential damages are specically excluded.* This warranty
gives you specic legal rights. You may also have other rights which vary from
state to state.
*Because some states do not allow the exclusion of incidental or consequential
damages, this exclusion may not apply to you.
SYMPTOM COMMENTS/SOLUTIONS
If the lter does
not start. .
If the LED Light
won’t turn on. . .
• Make sure that the Airline Tubing and Diffuser Tube
are attached properly and that the O-Ring in the Diffuser
Tube is in place.
• With dry hands, make sure the Air Pump is plugged
into a working electrical source.
• Make sure that the AC Adapter is plugged into an
electrical source. Check to make sure that the AC
Adapter Jack is inserted fully into the plug on the back
of the LED Light Box.
Troubleshooting Guidelines
Customer Support: 800.526.0650 • www.tetra-sh.com
11/11 P/N 29133-908
IMPORTANT:
Always unplug your
LED Aquarium Kit when
inspecting or disassembling
for any reason
LED Aquarium Kit
For Optimum Performance
1. Replace lter cartridge (Tetra Cartridge size small)
every 2 to 3 weeks for optimal sh health.
A
vailable at your local retailer.
2.
NEVER
plug the Air Pump in without water
in the Aquarium.
3.
NEVER
immerse Air Pump in Water. Air Pump
NEVER needs oil.
4.
Clean outside of Air Pump with damp cloth
and mild deter
gent.
Replacement
Filter Cartridge
Tetra Whisper
Bio-Bag size small
2
3
4
IMPORTANT SAFEGUARDS
WARNING: To guard against injury, basic safety precautions should be observed, including the following.
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
5
GloFish
®
29133_908TLEDAK1&halfgMassManual_11_11.indd 1 11/22/11 9:01 AM