Using a USB/Flash Card 11
Helpline No. UK/Northern Ireland 01270 508538 Rep.Ireland 1800 995 036
Web Support www.quesh.co.uk
Model No: 44163
20
1. In order to play a USB or Flash card, you must place it into the
correct slot located on the front of the micro system.
2. Now press the DVD/USB/CARD until the selected mode.
3. The same menu as the CD (as shown on the previous page) will then
display allowing you again to navigate through the folders and files
of the player.
4. Move down to the tabs at the bottom of the menu to select whether
you want to search for music, pictures or movies and press enter to
confirm.
Note: The music on the USB/flash card should be in MP3 or WMA format
Using The Radio
1. Press the input button on the remote control or swivel knob on the
front of the micro system until either FM/AM is displayed on the
VFD.
2. To do a manual scan simply press the search button left or right
continually until you have found a strong signal, once found you
can store this station into the micro system’s memory by pressing
the MEM button on the remote once then while the number is
flashing select a channel number to store this to then press MEM
again to store.
3. In order to do an autoscan press and hold the search left or right.
4. Once you have found and stored your channels you can either
press the corresponding number to choose your stored channel or
press the station left and right.
5. If you wish to search on AM then press the FM/AM button to
switch.
To Next Page
Loading...
