OPERATION – TUNER
TUNING
1. Press POWER to switch on the unit.
2. Press TUNER button.
3. Select the tuning band range by pressing the STOP/BAND button.
4. Press
SEARCH/CLK for few seconds, then release the button.
– The tuner will automatically search for the first transmitter of sufficient strength.
– Repeat this procedure if you wish to select another station.
5. To tune to weak stations, briefly depress SEARCH/CLK continuously until you read
the correct frequency or the reception is at its optimum.
PROGRAMMING OF PRESET STATIONS
1. Select the tuning band range by pressing the STOP/BAND button.
2. Tune to the desired station as described under Tuning.
3. Press MEMORY/CLK ADJ. "MEMORY" will start to flash.
4. Press REPEAT/M-UP to assign a number (1-10) to the preset station.
5. Press MEMORY/CLK ADJ again. The frequency, preset number and stereo setting are now
entered in the memory.
6. Repeat this procedure to store other frequencies and preset in the memory.
TUNING TO PRESET STATIONS
Select a number between 1 and 10 by pressing:
– REPEAT/M-UP button.
OPERATION – COMPACT DISC
INSERTING THE DISC
1. Press CD key.
2. Press OPEN/CLOSE key to open the CD door.
3. Insert a CD in the tray.
4. Press OPEN/CLOSE key to close the CD door.
The CD-player starts and scans the contents list of the CD. After a few seconds, the total playing
time and number of tracks appear on the display.
6
SELECTING A DIFFERENT TRACK DURING PLAY
1. Press
SEARCH/CLK until the required track number appears in the display.
2. Shortly appear this; the chosen track will start playing.
STARTING AGAIN WITH THE TRACK THAT IS CURRENTLY PLAYING by pressing
SEARCH/CLK once. The track will be started again from the beginning.
SEARCHING FOR A PASSAGE DURING PLAY by holding
SEARCH/CLK pressed down to
search for the required passage. If you release the button, play will continue. The volume will automatically be
reduced to a low level during search operation and will return to its normal level when the search button is
released.
PROGRAMMING TRACKS
Up to 20 tracks can be store in the memory.
1. Load a CD as described under Inserting the disc.
2. Press MEMORY/CLK ADJ to start programming.
3. Press
SEARCH/CLK to locate a particular track. The track number is displayed on the LCD.
4. When you have found the correct track number, press MEMORY/CLK ADJ to store it in the memory. The
display will show the programmed tracks.
5. To stop programming, press STOP/BAND once.
6. The programming will automatically stop if no button is pressed in a period of
10 seconds.
REVIEWING THE PROGRAM
1. Press MEMORY/CLK ADJ to review of the tracks currently programmed will begin. The tracks will be
displayed on the LCD.
2. Press MEMORY/CLK ADJ again for going to the next.
PLAYING A PROGRAM
1. Press PLAY/PAUSE .
2. Play starts with the first track of the program.
3. When all tracks have been played, the CD player stops.
CLEAR PROGRAM TRACKS
Opening and closing the CD tray will erase all programmed tracks.
7
To Next Page
Loading...