ELECTRICAL SAFETY (Continued)
Always unplug from the power source when any electrical apparatus is not in use.
Do not abuse or damage a power cord. If any power cord is damaged, it must be replaced by the
manufacturer, its service agent or a similarly qualified person in order to avoid a hazard. A
replaceable cord must be replaced with an authorised replacement from an authorised service agent
only.
Only use attachments/accessories specified by the manufacturer.
Unplug this apparatus during lightening storms or when unused for long periods of time.
Attention is drawn to the environmental aspects of disposing of any battery.
Refer all servicing to qualified personnel. Servicing is required when the apparatus has been
damaged in any way, such as when the power supply cord or plug is damaged, liquid has been
spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped. Do not attempt to service any double insulated
apparatus. Double insulated apparatus requires specialist servicing and knowledge to retain the
safety of the apparatus.
WARNING. Do not use any electrical apparatus outdoors. If any electrical apparatus is to be used
outdoors, use a suitable Isolating transformer or Electrical Safety Switch (RCD).
For household use only, this apparatus is not intended for commercial use.
If this apparatus is to be used by a third party, please supply these instructions with it.
No liability will be accepted for any personal injury or damage caused by failure to follow these
instructions.
12
CARE AND CLEANING
Before cleaning.
When not in use or before cleaning, always disconnect the equipment from the mains supply.
Cleaning guide.
Regularly clean the outside of the equipment with a soft damp cloth and dry it with a dry towel. Do not immerse
in water. Do not use harsh solvents to clean the plastic components.
Storage
When not in use store the Antenna and these instructions in a dry place.
TECHNICAL SPECIFICATIONS
Power Supply: AC power 230-240 ~ 50 Hz
Output Power (Per Channel): 12.5 watts RMS into 4 ohm
Power Consumption: 70W
Radio Section
Frequency Range: AM 522 - 1620 KHz
FM 87.5 - 108 MHz
Compact Disc Section
Frequency Response (-6dB): 20-15,000 Hz
Signal-to-noise Ratio: 50 dB
Harmonic Distortion: 0.4%
Channel Separation: 40 dB
CONTINUOUS IMPROVEMENTS ARE BEING MADE TO OUR EQUIPMENT BOTH IN QUALITY AND
PERFORMANCE, THUS WE RESERVE THE RIGHT TO ALTER SPECIFICATIONS WITHOUT NOTICE.
13
To Next Page
Loading...