11 INSTALLATION
The installation must be performed by qualified personnel.
11.1 Precautions
Make sure no connections (wires or cables in
general) or hydraulic ducts of fuel or safety pneumatic
devices are damaged during the installation.
Make sure the installation does not affect the
operation of vehicle controls, in particular of the brakes
and in general of the safety devices.
Make sure the various components around the
OBD diagnostic socket do not damage the device during
its installation.
Make sure the position of the device does not
interfere with driving.
11.2 Device Power Supply
TMD NANO is designed to be used ONLY on vehicles with
12 V DC power supply and chassis connected to the negative
pole.
The device is powered via the vehicle's OBD socket only.
Do not supply the device using external batteries
or through sources that differ from those specified in this
manual.
27
en
To Next Page
