Page 14
N Hopley. Sep 2015. TI-Nspire OS4.0
Page 14 - Resetting Press-to-Test Mode between Assessments
When Press-to-Test mode is first enabled, the memory is cleared and the TI-Nspire is
ready for an assessment.
After that assessment, your TI-Nspire may contain information on the Scratchpad or in
saved Documents.
This information needs to be cleared before going into the next assessment, whilst
keeping the same Press-to-Test mode settings.
To reset the memory, keeping the same Press-to-Test
mode settings, do the following:
Switch the TI-Nspire handheld off.
Whilst holding down the d key, press c
This will give the screen shown on the right !
Select
After a short pause, it will show this screen !
Your TI-Nspire is now ready to use in your next
assessment.
To Next Page
Loading...
