Installing and Activating TI Software 11
Basic Installation
Volume licenses. - If you are planning a basic install, it is recommended
you first review the setup.ini as covered in the “Advanced Installation -
Volume” section to see if an advanced install would work better for you.
It’s not necessary, but it may save you time. For example, by entering the
license number in the setup.ini, you can skip entering the license number
again for each machine.
Concurrent licenses. If performing a basic installation for the client
software, you must install the TI-Admin on the license server. Also, it is
highly recommended that you review and edit the setup.ini before
performing a basic installation. For more information, see Advanced
Installation - Concurrent.
Installation
These steps assume you have already acquired the client software either
from a CD or the TI Education Technology web site.
1. Run the TI-Nspire™ installer file (.exe).
The Welcome Screen opens.
2. Click the software option you want to install.
• Depending on your purchase, this screen may present Teacher,
Student, Handheld, or other options.
• In the following example, the selection TI-Nspire™ Teacher
Software or TI-Nspire™ CAS Teacher Software is displayed.
• Note the blue border (darker border if viewing this document in
back and white) around the computer image in the picture. This
indicates which item is selected. The default is Numeric.
• If installing TI-Nspire™ Navigator™ software, both numeric and
CAS versions are installed. You can use either one at different
times but they cannot run concurrently.
To Next Page
Loading...
Need help?
General
